BruceK
Well-known member
What Scottie said. If the hydraulic ram is at centre point and the bellcrank at 90 then the error is not there and you should rewind the cable onto the steering so the steering wheel comes out at dead centre.
However if the steering helmet has come off in the past and the bell crank removed to facilitate this then it is possible the pin has been inserted incorrectly on reassembly accounting for a sudden change. (But as above I am not 100% on this as my system with a tie bar works somewhat differently)
However if the steering helmet has come off in the past and the bell crank removed to facilitate this then it is possible the pin has been inserted incorrectly on reassembly accounting for a sudden change. (But as above I am not 100% on this as my system with a tie bar works somewhat differently)