Recent content by Mister E

For the extra cost of getting one made you could purchase a sewing machine that would do the job. Then you can use it for other stuff after.

Can this be pumped directly overboard or does it need something adding to neutralise it?

Ok enough can we stick to the problem of cleaning water tanks.

My father was a landing craft comander as well. Not sure of the date he landed. So he would have used the charts as well. I have never given the amount of charts needed for the landings before.

So what can be used and pumped overboard into the sea? Can I use endosan? Please consider what the water companies are pumping out when giving replies.

Thank you for the feedback, others might find it useful in the future. An electric pump can save the need to bleed the injectors but as you say does not replace proper technique. Please to hear it is now running.

London Chartplotters have fantastic customer support. Especially for something ten years old, what a fantastic advert for Steve. Some people will complain about anything.

Is there a way of doing the using a proper pen and real paper?

The tow eye is designed for side loads as when towing the bar or rope is not always in a straight line. Thus giving a higher side load.

Petrol station at Gallows Point Beaumaris just behind the boat yards.

I have a similar problem with a Nuffield tractor. The filters were changed and the system bled but now the lift pump is leaking air. This is not uncommon as the lift pump when operated by hand diaphragm moves a greater distance and can split or not work properly.

Sounds like something useful for our boat as well.

Any news on the starting?

Thus type of tub is the best to use with the mini gun. It has a plate inside that has a hole in the middle. You put the tube over the hole and gently press while pulling the filling bar out. A full size grease gun would take over 10 years to empty if just used on one boat. If loaned out it...

You remove the top with the lever by unscrewing. With the bar at the other end of the cylinder in the shortest position put the threaded part in the tub of grease. Then pull the bar handle out on the non threaded end and it will suck the grease in. You should be able to hook the filling bar in...